Exemplary drawing.
Air supply requirements
•
Supply tool with a maximum pressure according to the technical data of this unit
of clean, dry air. Higher pressure drastically reduces tool life and/or can cause
several injury.
•
Connect tool to air line using pipe, hose and fitting sizes shown in the diagram
above.
•
Do not install a quick coupler directly into the air tool handle.
•
In order to have the tool working to full satisfaction the minimum air delivery must
be at least 10% higher than the indicated air consumption of the air tool.
•
Please consult the technical data in this instruction manual.
Pneumatic tool and safety instructions
•
The goal of Bendel Werkzeuge is to offer tools that help your work safely and
efficiently.
•
The most important safety device for this or any tool is YOURSELF.
•
Your care and good judgment are the best protection against injury. All possible
hazards cannot be considered here, but we have tried to highlight some of the
most important ones.
•
This tool may only used by qualified people.
•
This tool and its accessories must not be modified.
•
Do not lay down the device before all the rotary parts stopped.
•
Do not keep the air tool running while carrying it.
•
Maintain a firm grip on the power tool and position your body and arm to allow
you to resist kickback forces. Always use auxiliary handle, if provided, for
maximum control over kickback or torque reaction during start-up. The operator
can control torque reactions or kickback forces, if proper precautions are taken.
•
Never place your hand near the rotating accessory. Accessory may kickback
over your hand.
•
Switch off the unit immediately in case of blocking or twist. Disconnect the air
supply and do not switch on again until the problem is solved. Understand the
reason why the tool has been blocked and make sure that this situation will not
occur once more by counteract accordingly.