page 2
Using and Setting the Timer
The dry bath has a built-in digital timer function that
sounds a “beeping” alarm and turns off the heat
when the set time has been reached.
Press the
Mode
button to illuminate the
Timer
lamp and place the dry bath into the timer set mode.
Use the
Up
and
Down
arrow buttons to set the desired time in one minute increments on the
display. Once time has been set, press and hold the
STAR/STOP
button to start the timer. The dry
bath will
make a “beep” sound and automatically begin the timer. The display will revert to showing
the well temperature and the red
Timer
lamp will be extinguished. When the display shows the well
temperature, pressing the
Mode
button will cause the display to show how much time remains on
the timer in minutes.
When time has expired, the dry bath will briefly sound the
“beeping” alarm, turn off the heater and
turn off all lamps. The display will show a set of chara
cters that represent the word “OVER” with
only a partial R shown. At this point the user can press the
START/STOP
button to start the timed
cycle over again. The user can also use the
MODE
button to enter the timer mode and change the
time setting.
It is best to allow the dry bath to first reach the desired temperature before setting and using the
timer function. ALWAYS SET THE TIMER TO 0000 WHEN USING THE DRY BATH WITHOUT
THE TIMER FUNCTION AS THIS WILL PREVENT SHUT OFF OF THE HEATER FUNCTION IF
THE TIMER IS ACCIDENTALLY STARTED.
User Calibration Function
The dry baths are calibrated at the factory. They also have a user calibration capability if needed
for field calibration. Please contact the factory to access this feature.
ERR Code on the display
If the dry bath temperature sensor is shorted or senses an ambient temperature below 0C, the
display will show the error code ERR.
Warranty:
The dry bath comes with a 1-year warranty.
Tel:
908-769-5555
Fax: 908-222-1864
Rev. 7-10
