Assembly Instructions
1. Remove two bolts located on either side of extractor head. These bolts are used only for shipping and storage
purpose.
2. Locate three spring loaded mounting bolts and align with mounting brackets on bottom of bowl. Twist bowl to lock
into place on the body of the machine.
3. Attach dome to bowl with three screws provided.
Wiring Diagram
Operating Instructions
1. Plug unit into a properly grounded 120 volt power supply.
2. Be sure to keep hands and loose clothing away from the spinning head.
3. Fill spinning head with desired amount of sugar floss (1/8 cup = an average cone)
4. Turn on MOTOR switch.
5. Turn on HEAT switch.
6. Once the head heats up floss will begin to melt and create cotton candy.
7. Using a paper cone collect the cotton candy from the edges of the bowl in a circular motion.
8. Repeat steps 3-7 until the desired amount of cotton candy has been produced.
9. Turn OFF motor and heat switches when finished making cotton candy.
Cleaning
1. Make sure unit is unplugged and has had time to cool down before cleaning. The ZEPHYR COTTON CANDY
MACHINE breaks down to – body, bowl, dome, and extractor head for easy cleaning.
2. After excessive build up of sugar in the extractor head, unplug the unit. Remove the extractor head by
disconnecting it from the unit. Allow the extractor head to soak in hot water for at least 15 minutes. Let dry and
replace on the unit.
3. Remove bowl and dome and wash with soap and water. Use wash cloth to wipe clean and let dry.
4. Use a slightly damp, non-abrasive sponge or non-abrasive towel to wipe clean the outside of the unit, wipe with a
non-abrasive towel to dry. Do not use excessive water when cleaning this unit.
Page 2
