S.p.A.
FT
7500
6
•
If the engagement of the second forw ard speed is difficult, it is possible to adjust it by means of
the register of the lever Fig.2 Ref.”G”.
•
If the belt of the reverse gear slips or tow w hen disengaged, adjust the registers of Fig2 Ref.”I” or
Fig 6 Ref.”D”.
•
It is also possible to register the w heel unlocking device command w ire (in case of engaging or
disengaging malfunction), through the register of Fig.2 Ref.”N”. (see Pics.6 Ref.”A”).
•
The high grass mow er has a double blade, in order to improve the breaking of cut material.
•
When the mow er is used in open fields or w oody areas, it is possible to bring these modifications
to the machine:
1.
remove the right side door (ref. A fig. 11);
2.
mount the deflector cap (ref. B fig. 12);
3.
mark the boundary of the w orking area as it 's show n in the draft below , before using the
machine. (Respect the measures indicated in the draft);
4.
put w arning signboards all around the w orking area. The signboards must report this inscription:
“Danger: throw ing objects. Do not cross the enclosure.”
A
B
ABCD = 20m X 20m (enclosed area)
A*B*C*D* = 15m X 15m (w orking area)
C
D
Adjustment of the blade pulley belt tightener:
1. Disconnect the spark plug cable (ref. 18 page 2), before starting any operation.
2. Remove the front hood by unscrew ing the four screw s that fasten the cover (Pics 5 Ref. "B").
3. Engage the blade engagement lever (Pics 2 Ref. "B") so that the belt tightener, located beside
the driving shaft, is in engaged position.
4. Adjust the belt tension (Pics 7 Ref. "A") w ith the register (Pics 6 Ref. "C")
5. If this adjustment is not effective enough the operator can move the entire cutter assembly
6. Loose the tw o screw s
(Pics 7 Ref. “B”)
blocking the hexagonal pipe , adjust the register screw
Fig.8 Ref.”A”, to shorten or lengthen de device follow ing needs.
7. Tighten the tw o screw s (Fig.7 Ref.”B”) and check that in brake engaged position the brake w ith
brake lining (Fig. 7 Ref.”C”), is correctly coupled w ith the pulley. If not, adjust the brake travel
through the adjustment rod Fig.7 Ref.”D”.
•
If the machine has been subjected to heavy use, the discharge may tend to jam. If this happens,
the operator should: 1) raise the cutting height and 2) reduce the w orking section if the
grass is too high or thick.
•
If the high grass mow er is used near a w all or sidew alk, take care not to bang the blade as this
could lead to damage to the machine.
A* B*
D* C*
2,5 m
