SpA
BL 10
5
STARTING STAGES
1. The fuel tap must be open Ref. 3” Fig N°1.
2. Position the accelerator lever in “START” position (see Fig. N°9 Ref, A).
3. Make sure that the transmission engagement lever is lifted up, see Fig. N°11 Ref A.
4. Grip the starter handle with one hand, Fig. N°11, pull gently until you feel resistance and then pull hard. When the motor has
started running, do not let go of the cord suddenly, but accompany it until fully rewound.
5. In all BL10 models, when the engine has been started, allow the accelerator lever to return to mid-stroke (see Fig. N°9).
Allow the engine to warm up properly before starting work.
6. To move the motorised hoe forward, grip the handles firmly and lower the lever Fig. N°6; in this way, transmission is
automatically engaged.
7. To stop the engine, move the accelerator handle to “Stop” position (see Fig. N°9) and, close the fuel tap. DO NOT tie the
transmission engagement lever to the handlebar knob while using the motorised hoe.
Pict. n. 8 Pict. n. 9
"
•
The tiller is equipped with a small front transfer wheel that can be removed or rotated upwards, as shown in picture 7,,
during the hoeing work by operating on the adjusting knob (Ref.”10”, Fig.1).
•
To move the motorised hoe forwards, use the transmission engage-disengage lever Fig. N°10.
•
Always do this while the engine is idling, and, in any event, press the engaging lever slowly and then increase revs with the
accelerator lever.
•
The tiller is 40 cm wide and it has got 4 blades: 2 blades on each side.
•
The cutting part of the tiller must face the front of the machine.
•
The spur is secured by a through-pin (see Fig. N°12, Ref.”A”) and its height can be adjusted in 3 different positions
according to the hole selected for securing - the hole is on the spur.
#
Pict. n°11
Содержание BL 10 Series
Страница 1: ...S p A SERIES BL 10 14 07 2008...
