IMPORTANT NOTE:
Your Siesta chair is shipped with the lift mechanism
disconnected from the chair to avoid possible damage
caused by mishandling in shipping. Follow the
directions below to connect the lift mechanism
to the chair.
1. Remove the Siesta chair from the carton.
CAUTION! To avoid damage to the upholstery,
do not use a knife to open the carton.
2. Carefully remove the protective packing materials.
3. Remove the back panel from the chair by
unscrewing four (4) Phillips screws holding the
back panel in place.
4. Use a wire cutter or side cutter to cut and remove
the plastic “zip-tie” holding the top of the lift
mechanism to the chair frame.
5. Pull the retaining clip out of the pin and remove
the pin from the bracket on the chair.
6. To connect the lift mechanism to the chair:
a. Have a helper pull the chair up on the frame
until the bracket is even with the black plastic
fitting on the top of the lift mechanism.
b. Align the black plastic fitting with the
bracket.
c. Insert the pin through the bracket and the
fitting.
d. Push the retaining clip through
the hole in the end of the pin
to keep it from sliding out
of the bracket.
7. Replace the back panel.
SIESTA CHAIR ASSEMBLY
5
BRACKET
RETAINING
CLIP
LIFT
MECHANISM
Produced by: J. Baer
Date: 06/06
Amended: 02/07
Version: 1
Shampoo Seating System
Siesta
PIN
”ZIP-TIE”
CUT AND REMOVE
BLACK
PLASTIC
FITTING
RAISE
CHAIR
4000978
