34
Problem Solving Section
For your assistance, we have listed below a few common problems.
Phone does not work, check the following:
1.
BASE UNIT
is plugged into power source.
2.
HANDSET
is charged.
3. TONE/PULSE SELECT switch is in the right position.
4. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK.
Range of phone limited, check the following:
1. ANTENNA on
BASE UNIT
is raised.
2.
BASE UNIT
is centrally located in your residence.
3.
BASE UNIT
is not located near appliances.
No dial tone, check the following:
1. TELEPHONE LINE CORD plugs are connected to the TELEPHONE JACK and TELEPHONE
LINE CONNECTION JACK.
2.
BASE UNIT
is plugged into power source.
3. If you had a power failure or had unplugged the
BASE UNIT
, replace the
HANDSET
on the
BASE UNIT
for 2 to 5 seconds to reset the system.
Received signal flutters or fades, check the following:
1. BATTERY PACK in
HANDSET
is fully charged.
2.
HANDSET
is not too far from the
BASE UNIT
.
3. ANTENNA on
BASE UNIT
is raised.
Interference on reception, check the following:
1. Noise may be picked up from electrical products in the home or electrical storms. Generally,
this noise is a minor annoyance and should not be interpreted as a defect in your system.
(See Technical Information on page 36.)
2. Choose an alternate channel using the
scan
button on the
HANDSET
.
Long Distance
]
L-D-C
^
Indicator is not ON when receiving long distance call, check the
following:
1. Your local telephone company can provide the Area Code on an incoming long distance
call.
Problem Solving
All manuals and user guides at all-guides.com
