•
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not
replaced at the same time, if disposed in fire, or if an attempt is made to charge a battery not intended to be charged.
•
Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions:
•
This device may not cause harmful interference
•
This device must accept any interference received, including interference that may cause undesired operation
Important:
Changes or modifications to this unit not expressly approved by Bellsouth could void your authority to operate
this unit. Your radio is set up to transmit a regulated signal on an assigned frequency. It is against the law to alter or adjust
the settings inside the radio to exceed those limitations. Any adjustment to your radio must be made by qualified
technicians.
To be safe and sure:
•
Never open your radio’s case.
•
Never change or replace anything in your radio except the batteries.
Your radio might cause TV or radio interference even when it is operating properly. To determine whether your radio is
causing the interference, turn it off. If the interference goes away, your radio is causing it. Try to eliminate the interference
by moving your radio away from the receiver. If you cannot eliminate the interference, the FCC requires that you stop
using the radio.
Hazardous Environments:
Do not operate the radio in hazardous environments. Explosion or fire may result. Do not
operate the radio near unshielded electrical blasting caps. Under certain conditions, radios can interfere with blasting
operations and may cause an explosion. Turn your radio OFF to prevent accidental transmission when in a blasting area
or in areas posted: “Turn off two-way radio.” Construction crews often use remote control RF devices to set off explosives.
Care and Safety:
To clean the radio, use a soft cloth dampened with water. Do not use cleaners or solvents because
they can harm the body of the unit and leak inside, causing permanent damage. Use a dry, lint-free cloth to clean the
battery contacts. Do not submerge the unit in water. If the unit gets wet, turn it off and remove the batteries immediately.
Dry the battery compartment with a soft cloth to minimize potential water damage. Leave the battery compartment cover
off overnight to ensure complete drying. Do not use the radio until the unit is completely dry.
SYMPTOMS SOLUTION
No power
•
Check the batteries. Ensure that the batteries are
installed properly.
•
The batteries may be weak.
•
Recharge your batteries by using the A/C
Adapter Charger.
•
Your batteries may be damaged. Replace old
batteries with new Lithium-Ion batteries.
Reception is weak
•
Press the UP button to increase VOLUME.
•
The receiving signal may be weak and/or out of
range.
Cannot change
channels
•
To change channels, press the MENU button
until the channel number flashes on the LCD
Screen.
•
Press the UP or DOWN button to change
channels.
•
Batteries may be weak.
Range is limited
•
Batteries may be weak
•
Recharge batteries if the BATTERY LEVEL
indicator is low.
•
The maximum range will vary depending on
terrain and environment.
•
Open fields provide the maximum range, while
steel/concrete structures, heavy foliage, and
use in buildings and in vehicles may limit the
range significantly.
FCC INFORMATION
