Bellman & Symfon BE9026, Быстрый старт

Страница: 4 / 4

Changing the radio key
If your Visit system is activated for no reason, there is probably a nearby system that triggers yours. In order to avoid radio
interference you need to change the radio key on all units. The radio key switches are located under the transmitter cover.
Here is how you change the radio key:
1 Open the transmitter front cover and move any radio key switch to the up (on position) to
change the radio key. By default, all radio key switches are positioned down (off ).
2 Press and hold the test/function button on the receiver until the green and yellow Visit LEDs
blink alternately. Release the button.
3 Press both test buttons simultaneously on the transmitter within 30 seconds to send the new radio key.
4 All Visit LEDs on the receiver blink 5 times to show that the radio key has been changed. It then returns to normal mode.
Note: All Visit units must be set to the same radio key in order to operate as a group.
°
5
Troubleshooting
On
Off
If Try this
The LEDs blink in orange every minute
ƒ
Replace the batteries. Only use 1.5 V AA (LR6) lithium or alkaline batteries.
The transmitter LED lights up in green
but the receiver doesn’t respond
ƒ
Check the the transmitter batteries and the receiver batteries and connections.
ƒ
Move the receiver closer to the transmitter to make sure it’s within radio range.
ƒ
Check that the units are set to the same radio key, see Changing the radio key .
The transmitter LED doesn’t light up
when the phone rings or when an
accessory is triggered
ƒ
Press the test buttons on the transmitter. If the LED lights up in green, check all
connections. If the LED doesn’t light up in green, replace the batteries. Only use
1.5 V AA (LR6) lithium or alkaline batteries.
The transmitter LED doesn’t light up
when I press the test buttons
ƒ
Replace the batteries. Only use 1.5 V AA (LR6) lithium or alkaline batteries. If the
LED still doesn’t light up, contact your retailer for service information.
The receiver is activated for no
apparent reason
ƒ
There is probably another Visit system installed nearby that triggers your
system. Change the radio key on all units, see Changing the radio key .
1 2 4
RADIO KEY
On
Off
Visit telephone transmitter
3