9
Adjusting Rinse Aid Dispenser
The rinse aid dispenser cap has 6 settings. Always start from "4" but if dish spots and streaks serious please set
it to “5” or higher to increase the amount of rinse aid. Factory default set is “5”.
NOTE:
Increase the dose if there are water drops or spots on the dishes after washing. Decrease if there is
sticky & whitish stains on the dishes, or bluish stains on glassware and knife blades.
1.2 Fill The Detergent
Detergents with its chemical ingredients are necessary to remove dirt, crush dirt and move it out of the
dishwasher. Most of commercial quality detergents are suitable for this purpose. Based on their chemical
composition, dishwasher can be split in two basic types:
-
conventional, alkaline detergents with caustic components
-
low alkaline concentrated detergents with natural enzymes
The use of "normal" washing program in conjunction with concentrated detergents reduces pollution and is
good for your dishes; these washing programs are specially matched to the dirt-dissolving properties of the
enzymes of the concentrated detergent. For this reason "normal" washing program in which concentrated
detergents are used can achieve the same results that can otherwise only be achieved using "intensive"
program.
Detergent tablets of different brands dissolve at different speeds. For this reason some detergent cannot
dissolve and develop their full cleaning power during short program. Therefore please use long program
when using detergent tablets, to ensure the complete removal of detergent residuals.
There are 3 sorts of detergents
-With phosphate and with chlorine
-With phosphate and without chlorine
-Without phosphate and without chloride
How to fill
1.
Press the lid release button to open the lid.
2.
Fill detergent into detergent compartment or pre-wash compartment (MIN. of detergent compartment
means about 20g and for pre-wash is about 5g).
3.
Close the lid until it locked.