Belling Design BDC95IN2F, Инструкция по эксплуатации, Страница: 20 / 28

20
INSTALLATION INSTRUCTIONS
How to stick the gasket:
Fitting - installing:
•
The cut out sizes are:
•
Ensure that there is a distance of 50 mm between the cutout
•
and the wall or sides.
The hobs are classified as “Y” class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall at
one side.
On the other side, however, no unit or divider must stand higher than the
•
hob.
The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
•
Do Not install the hob to the top of a not ventilated oven or a dishwasher.
•
To guarantee under the bottom of the hob casing a space of 30 mm to ensure a good air
circulation of the electronic device.
•
If a drawer is placed under the work, avoid to put into this drawer flammable objects (for
example: sprays) or not heat-resistant objects.
•
Materials which are often used to make worktops expand on contact with water. To protect
the cut out edge, apply a coat of varnish or special sealant. Particular care must be given to
applying the adhesive joint supplied with the hob to prevent any leakage into the supporting
furniture. This gasket guarantees a correct seal when used in conjunction with smooth work
top surfaces.
Stick the gasket (2) two
millimeters from the external
edge of the glass, after removing
the protection sheet (3).
L(mm) W (mm) H (mm) D (mm) A (mm) B (mm) X (mm)
BDC95INF 880 520 55 51 810 490 50 min.
The hob must be installed by suitably qualified people in accordance with local regulations.
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
The gasket supplied with the appliance also maintains the position of the appliance, it is not
necessary to use another fixation system.
This installation has to be done carefully, in conformity of the following drawing.