Bellhowell BH20TWS, Руководство пользователя

Страница: 4 / 7

NOTE:
When TWS is enabled, you only need
to Bluetooth pair to one speaker. On one
speaker, press and hold the button for 4
seconds. A blue/red LED will flash rapidly to
indicate that it is powered on and searching for a
Bluetooth source to pair with
.
G
o into your phone/tablet’s Bluetooth settings
and enable Bluetooth. Next, enter the Bluetooth
device list and select
BH20TWS . After selected,
wait a few seconds for the pairing to complete.
Once the pairing is successful, you will hear and
audible tone from the speaker and a blue/green
LED will stay solidly lit.
This will connect your phone/tablet with the
master speaker which will wirelessly broadcast
the right audio signal to the slave speaker
.
NOTE: TWS is only available in Bluetooth
mode. You cannot link two speakers in AUX or
MicroSD mode.
NOTE:
Powering off one of the BH20TWS
speakers will power disconnect both off them. If
you power both of them back on within two
seconds of each other, they will automatically
relink and reconnect to your Bluetooth source.
Connecting BH20TWS via Auxiliary Input
If you would like to use a device that is not
equipped with Bluetooth technology, simply slide
the power switch to the MP3 position. Connect
the included auxiliary 3.5mm cable from your
device to the
USB input at the base of the
BH20TWS. Tap the button to cycle
between MicroSD and Line-In modes.
Listening to Music from a MicroSD Card
If you would like to listen to music loaded on a
MicroSD card, simply slide the power switch to
the MP3 position and insert a MicroSD card into
the base of speaker. Be sure that music is in