Bellfires VENTO CLASSIC LARGE, Инструкция по использованию и ежедневному обслуживанию

Страница: 20 / 96

20
Bell fi res
English
Instructions for use
3 USING THE APPLIANCE FOR THE FIRST TIME
The gas fi re is coated with a lacquer layer resistant to high temperature. During the fi rst
hours of operation, the burning in of the lacquer may result in an unpleasant smell. This
is harmless, however. Operating the gas fi re at full capacity for a few hours, while
ventilating the room, will eliminate the smell.
After using your gas fi re for the fi rst few times, you may be aware of a light deposit on
the inside off the glass. This is caused by the paint curing. Once your fi replace has
cooled down, this deposit can be removed with glass cleaner or ceramic hob cleaner.
4 DAILY MAINTENANCE
• Ensure that as little dust, and as few particles of cigarette smoke, candles and oil
lamps as possible pollute the air in the room in which the appliance is used. Heating
of these particles by the convection system of the appliance could lead to
discoloration of the walls and ceiling. It is therefore very important to ensure that the
room in which the appliance is located is suffi ciently ventilated. Regularly remove
any dust deposits from behind the (white) panel door (operating unit) by means of a
vacuum cleaner.
Important: • Regularly clean the glass on the inside of the appliance with
glass spray or ceramic hob cleaner.
Attention!! If the glass is not cleaned on time,
this can result in becoming dull and
diffi cult, if not impossible, to clean.
(See installation instructions for
dismantling/assembling the glass.)
• If the glass is broken or cracked, it must be
immediately replaced before operating the
gas fi re again.
Ceramic heat-resistant glass may not be placed in
the glass container, but must be included in normal
household waste.
• If anything is spilt on the fi re, switch it off immediately and wait for it to cool
down suffi ciently before cleaning. Never use scouring powder, aggressive
cleaners or fi re polish on the gas fi re. Use only a dry lint free cloth.
• Heat resistant lacquer in aerosols can be obtained from your
distributor. During the yearly maintenance, the lacquer can be used to repair
small areas of damage.