9
STOPPING - HONDA GX200, GX240 & GX390
• Switch
OFF
the loads.
• Switch
OFF
the engine.
• Turn the fuel tap to the
CLOSED
position.
STARTING - HONDA GX200, GX240 & GX390
• Remove all objects placed on, or within one metre of the Pressure Washer.
• Open the fuel tap by moving the fuel
ON / OFF
lever fully to the right.
• If starting the engine from cold, set the choke
ON
by moving the choke lever
fully to the left. If restarting a warm engine, the choke is usually not required,
however, if the engine has cooled to a degree, partial choke may be required.
• Turn the engine
ON / OFF
switch clockwise to the
‘I’
position.
• Set the throttle to the idle position by moving the throttle lever fully to the right.
• Taking a
fi
rm hold of the frame with one hand, grasp the recoil starter handle with the other. Pull the recoil starter until engine
resistance is felt, then let starter return.
• Taking care not to pull the starter’s rope fully out, pull the starter handle briskly.
• Repeat until the engine
fi
res.
• Once the engine
fi
res gradually set the choke lever to the
OFF
position by moving it to the right.
• If the engine fails to
fi
re after several attempts, follow the Troubleshooting Guide.
• To stop the engine, set the throttle to idle and turn the engine
ON / OFF
switch anticlockwise to the
‘0’
position.
• Turn the fuel
OFF
STOPPING - Yanmar L100
• In preparation for stopping the engine, move the throttle lever to LOW position.
• Allow the engine to idle.
• Move the Throttle Lever to STOP position to stop the engine. Then, set the Key Switch to “OFF” position.
STARTING - Yanmar L100 Electric Start
• Insert the key into the key switch.
• Place the throttle into the mid-way postion.
• Turn the key clockwise to the START position. Release the key as soon as the engine starts, it will return to the ON position.
STARTING - Yanmar L100 Manual Start
•
Grasp the recoil starter handle.
•
Pull the handle out slowly until you feel strong resistance.
•
Slowly return the recoil starter to the initial position.
•
Push the decompression lever down and then release it. The decompression lever will automatically return to the original position
when the engine starts.
•
Grasp the recoil starter handle.
•
Pull the handle all the way out with a strong and even motion. Use two hands if necessary.
•
Slowly return the starter handle to the initial position.
•
If the engine does not start, repeat the procedure.
The max. engine running speed is pre-set by the manufacturer and must not be adjusted.
CAUTION
Throttle Lever
Choke Lever
Fuel ON/OFF
Lever.
Start and Stop Procedure
GB