Bell BellAire 3000, Инструкция по эксплуатации

Страница: 7 / 16

7
MAINTENANCE
TROUBLE SHOOTING
1. Your BellAire™ 3000 has a replaceable fuse providing maximum protection for the
inflator and/or your vehicle. See figure 4 for fuse replacement instructions.
2. Regularly check inflator air hose, 12 Volt cord and adapters for damage.
3. Keep the inflator dry, clean and free from oil and grease. Always use a clean cloth
when cleaning.
The inflator fails to run with the inflator power switch turned on:
• Check that the plug is fully inserted into 12 Volt cigarette lighter socket. See operation
instructions on pages 5-6.
• Your vehicle may require the ignition be turned to the accessory position for the ciga-
rette lighter to have power. The inflator should be used with the vehicle running.
• Check to see if the fuse in the 12 Volt lighter plug has blown. See fuse replacement
instructions in the maintenance section. See figure 4, above .
Inflator fails to stop at the auto shut-off pre-set pressure:
• Check to make sure auto shut-off pressure settings are being set correctly. See opera-
tion instructions on pages 5-6.
• Check that the correct pre-set pressure has been set.
12 Volt power cord gets hot:
• Make certain power cord is not coiled up or in a knot or damaged.
Pressure gauge appears to read incorrectly:
• Make certain when you attach the air hose nozzle to the tire stem that the gauge is
reading the current tire pressure before turning on the inflator switch.
• Wait 5-7 seconds for gauge to display proper pressure.
The inflator is running but the tire is not inflating:
• Turn off inflator and check that the air hose nozzle is securely attached to the tire valve
stem.
Turn tip counterclockwise to unlock Fuse Adapter Body
Fuse
(Replace with ACG glass 15 amp fuse only)
Adapter Body
12 Volt Adapter Fuse Replacement
— FIGURE 4 —