SECTION 501-211-102
TRANSMITTER
BOARD
TRANSMITTER
PLUG
RECEIVER
JACK
POTENTIOMETER
RECEIVER
BOARD
RECEIVER
UNIT
Fig. 2-G6AR Handset, Internal Assembly (G7AR and GSA are Arranged Similarily)
Do not use cleaning fluids or antirust
compounds on transmitter or receiver
units or other component parts of
handset. Discoloration or tarnish on
the silverplated contact surfaces
is
not
objectionable and no attempt should
be made to remove it.
4.03
The H4CT handset cord furnished with G6-,
G7-, and G8-type handsets is not available
for field use. If the original cord requires replacement,
modify and install an H4CJ cord as follows:
(1) Carefully remove outer plastic covering on
two white conductors with diagonal pliers.
Page 4
(2) Tone-out and identify one white conductor.
For identifying purposes, loose knots may
be tied in each end of this conductor, designating
it green. The other white conductor then
becomes yellow.
(3) Loop and tie or tape the excess length of
white conductors to approximate length of
red and black conductors.
(4) Insert conductors in transmitter bowl carefully
so as not to disrupt the printed board circuit.
BSP 501-211-102-i03_1970-10-04.jpg Scanned by Frank Harrell, (Cowboy Frank) Castle Rock, Colorado Mar 02,2012 22:07:46
