a) Remove the seal seat from the seal cap or gland.
b) If an inside seal, remove the seal using a pair of screwdrivers, to pry out the seal.
7. Clean the seal box, seal cap, or gland and shaft.
CAUTION:
Avoid touching the carbon face and ceramic face of the seal and
getting it dirty.
8. Place the seal seat in the seal cap or gland.
9. For an outside seal:
a) Install the seal seat with seal cap or gland (including the gaskets on either side of
the seat) over the end of the shaft and fasten to the motor bracket with four cap
screws and washers. Tighten seal gland cap screws evenly to avoid misalignment
one quarter turn past hand tight.
b) Leave the seal holding clips on the rotating part of the seal, lubricate the bore of
the seal with soapy water or other suitable lubricant such as International Products
Corporation P-80
®
, and install the rotating part of the seal on the shaft with the
rotating face toward the seal seat.
c) After the coupling assembly (see below), tighten the seal set screws on the shaft
and remove the seal holding clips. The seal is now set. Keep the seal holding clips
in case the seal has to be removed in the future.
Figure 12: Outside seal
1. Seal seat
2. Seal cap or gland
3. Seal seat gasket (seat to cap or gland)
4. Seal seat gasket (seat to motor bracket)
5. Shaft
6. Motor bracket
7. Seal gland cap screws
8. Washers
9. Rotating part of the seal
10.Seal set screws
10.For an inside seal:
6 Maintenance
20
Series e-80SC INSTRUCTION MANUAL
Содержание e-80SC Series
Страница 1: ...INSTRUCTION MANUAL P2002880 Rev C Series e 80SC ...
Страница 2: ......
