RK5039 Instructions
Page 2
P35855
www.belkin.com
Belkin Corporation
501 West Walnut Street
Compton, CA 90220-5221, USA
Tel: 310-898-1100; Fax: 310-898-1111
© 2005 Belkin Corporation. All rights reserved.
All trade names are registered trademarks of respective manufacturers listed.
Instructions - Vertical
Power Strips
1. Install 10-32 spring nut by holding
it horizontally in the slotted
horizontal, pushing and turning it
clockwise into a vertical position.
Repeat this step three times.
2. Install power strip mounting
bracket using the 10-32 x 3/4"
pan head screw.
3. Install power strip mounting clip
using the 10-32 x 3/8" flat head
screw.
4. Snap in your vertical power strip.
C
Note: Power strip mounting
brackets will also accept
Wiremold "Snap-on/Slide-off"
clips (included with Wiremold
power strips) used with 2"
housing.
Vertical Power Strip Facing Sideways
Vertical Power Strip Facing Back
