
8
4. Specifying the TCP/IP Parameters
you may be asked to load the Microsoft Windows
®
98 CD, and
to reload the software installation diskette, as necessary.
11. Click Finish.
12. Read, then close, the Notepad message confirming the
installation. It describes the requirements for configuring the
appropriate Ethernet connections and specifying the TCP/IP (or
other) protocol parameters. Turn to Section 4 in this manual for
additional information.
4. SPECIFYING THE TCP/IP PARAMETERS
This configuration procedure is identical to that of other network
interfaces, for example, an Ethernet card.
A. When the Belkin USB Ethernet Adapter is the only installed
network interface.
Select My Computer / Control Panel / Network. The Network
Configuration form appears. In this form, the USB Ethernet
Adapter icon should be visible.
Additionally, a new protocol icon with the title TCP/IP should be
visible. To specify the TCP/IP parameters, use the procedures
described in section C on page 9.
B. When another network interface is already installed in the
system.
Select My Computer / Control Panel / Network.
The Network Configuration form appears. In this form, the USB
Ethernet Adapter icon should be visible.
If the TCP/IP protocol was previously installed, a network
connection icon with the title TCP/IP -> USB Ethernet Adapter
should also be visible. To specify the TCP/IP parameters, use the
procedures described in section C below.
C. To specify the TCP/IP parameters for New Networks:
1. Select TCP/IP, (or TCP/IP -> USB Ethernet Adapter, if more