BELINEA 102015, Руководство пользователя

Страница: 5 / 12

MENU
SELECT/AUTO MENU SELECT/AUTO
Carefully lift the monitor out of the packaging and make
sure that all components are included (see fig. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
To set up the device, you need to assemble the monitor
stand. Join the stand base to the stand post. You should
be able to hear it slot in. Insert the screw enclosed, tight-
ening it with a coin or a screwdriver, so that the stand
base is attached securely to the stand post.
You can adjust the height of the base.
UNPACKING
Power cord
Audio cable

To connect the monitor to your PC ........................
1.
Make sure that the PC and monitor are unplugged.
2. Connect the 15-pin signal cable to the monitor and
the PC (see fig. 2a).
3.
The monitor is equipped with a DVI-D connector. If
you have a graphic card with a digital DVI-D con-
nector (24-pin socket), then connect one end of
the DVI-D cable (optional) to the DVI-D connector
of your monitor (see fig. 2b), the other end to the
computer.
CONNECTING

Connecting the audio cable ....................................
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio
input connector of the monitor (

in fig. 3) and the other
end to the Line-Out connector of the computer.
Figure 1. LCD Monitor
VGA cable
Figure 2a. Connecting the monitor to the PC
Signal cable
DVI-D cable
(optional)
Figure 2b. Connection via the DVI-D interface
DVI-D cable

To connect the monitor to the power source ........
1.
Connect the separate power cable (  in fig. 3) to
the monitor and a grounded outlet.
2. The monitor is equipped with a main power switch
located on the back, next to the power cable socket
(

in fig. 3).
MENU
SELECT/AUTO MENU SELECT/AUTO



Figure 3. Connecting the monitor to the power source
When the base of the monitor is extended, you can tilt
the monitor 90° (Pivot function).
Belinea 10 20 15 - Operating Instructions - 4
ENGLISH
1. First start your PC and then turn on your Belinea
monitor using the power switch (

in fig. 4). The
status indicator (

in fig. 4) should light up green.
2. Adjust the image to meet your requirements (see the
following sections “Basic Setup” and “Image settings
using the OSD menu”).
3. If there is no image displayed on the monitor, consult
the section “Troubleshooting”.
STARTUP