Belden GRASS VALLEY NV9641, Руководство пользователя

Страница: 32 / 111

22
Configuration
Options under XY/MD Model
Checkbox Options
The checkbox options section is just below the panel options section, enclosed in the same
box.:
MD Data
Routing Mode
Automatic If a machine control (i.e., data) level is involved in a route,
the system makes the route on the control level even if the
control port is in use on the source or destination device. It
breaks the previous control connection and then makes a
new control connection for the route in progress.
Manual If the control port is in use for the source or destination
device, the system takes all (selected) levels except control.
It
does not perform the control level route.
If the control port is not in use, the control level take occurs
normally.
To carry out a take on a machine control port that is in use,
the operator must first free the port by performing a
“tristate” take on the port, that is, taking the device (as a
source) to itself (as a destination) on the control level.
An operator can determine whether the control level is
free by switching momentarily to X-Y mode and examining
the destination’s levels on selection buttons.
Multidest
Device Limit
(Selectable in
multiples of 8)
The number of multi-destination entries you are defining.
(Strictly speaking, this is not a limit, but a
count .) The
default, and lowest value, is 8. The maximum is 512. (If you
have more entries than devices, you can leave some MD
destinations unassigned.)
Default Name
Set
System Name A list of “name sets” appears in the drop-down menu. The
name sets can be defined under the System Management
pane of NV9000-SE Utilities. Choose ‘System Name’ in this
list if you do not want, or do not care about, device name
aliases. Do
not choose ‘System Name’ if you are
configuring any ‘Name Set Toggle’ buttons.
a. See Defaults on page 83 .