Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 154 / 288

154 KAYENNE K-FRAME — Installation & Service Manual
Section 5 — Basic Configuration
Note Source name control is enabled only when the Connection Status and Source
Name Control
Enable buttons are both enabled (highlighted green).
ClipStore Configuration
ClipStore basic configuration includes preparing the Summit/Solo and
Kayenne K-Frame systems through licensing, IP addressing, software
installation, cabling, and GV Switcher menu configurations.
Summit/Solo Software Version
The latest version of the ClipStore server software is available on the Grass
Valley Switcher Software Download site.
CAUTION Do not use AppCenter Elite software for ClipStore from the Summit/Solo
server web site as it may not be compatible.
For more information about installing and updating AppCenter Elite soft-
ware, see the Summit/Solo manuals.
Summit Preparation
Setting the IP Address
The ClipStore Summit/Solo server is shipped with the following defaults:
• IP Address: 192.168.0.180
• Mask: 255.255.255.0
• Gateway: 192.168.0.1
• WINS: disabled (0.0.0.0)
• DNS: disabled (0.0.0.0)
You can temporarily change the default settings using Netconfig (see the
NetConfig Network Configuration Application Instruction Manual at
www.grassvalley.com).
To set a new IP Address at the ClipStore (Summit/Solo) server, see Setting
the Summit/Solo IP Address on page 160
.
The NetConfig Network Configuration Tool can be installed with the
K-Frame Switcher Installer software.