Belden Grass Valley KALEIDO-X16, Инструкция по установке и обслуживанию

Страница: 43 / 152

43
Frame Operation and IP Network Setup
Introduction
This chapter shows the multiviewer interfaces, explains the local operations that can be
performed, and it explains how to implement IP network connectivity with the multiviewer.
A Kaleido-X16 multiviewer system can be controlled in the following ways:
• In the housing frame, you can monitor card operating status of your Kaleido-X16 input
and output cards by looking at the card-edge LEDs (see Card Interfaces and
Troubleshooting , on page 43).
• The loading and management of layouts is handled by XEdit, accessed through a
dedicated Ethernet port (refer to the Kaleido Software User’s Manual;
see Related
Documentation
, on page 15).
• A GPI interface allows remote layout selection. See Loading a Layout , on page 98.
• The output resolution of the card can be controlled automatically through the EDID
interface with the display. See also Changing the Output Resolution , on page 40.
• The RCP-200 advanced remote control panel, and the Kaleido-RCP2 control panel allow
you to perform operations on the monitor wall, either by themselves or in association
with an external keyboard and a mouse. Refer to the RCP-200, Kaleido-RCP2, and
Kaleido Software documentation.
See Related Documentation , on page 15 .
Card Interfaces and Troubleshooting
Open the front cover to view the multiviewer’s LEDs.
Front view of the Kaleido-X16 frame (PSUs installed; front cover removed)
LEDs on the front of the frame (behind the cover)
Video Inputs
LTC
DVI Inputs SDTI
Reference Input
CF Activity
CPU
Severity
General Status