FX FUSION LC CONNECTOR
PX106498-EN REV C
Page 3 of 8
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
Fusion Splicer setup:
1.
Follow the manufacturer’s
instructions:
A.
Perform calibration and arc
check.
B.
Select the appropriate splicing
mode based on fiber type
(
SM
or
MM
).
C.
If applicable remove the left
fiber holder.
D.
Set the heating mode by
referring to the heat setting
table on the first page.
2.
Just before use, open the sealed
bag of the FX Fusion Splice-On SC
Connector Kit.
3.
Open the clamshell carefully by
lifting the top cover and sliding
your finger toward both sides
(
right
and
left
).
Clamshell open:
Splice protection sleeve
with spring
Rear housing with boot
Connector front
housing
Ferrule stub assembly
Ferrule stub’s
dust cap
