Belden 942 034-001, Руководство пользователя

Страница: 22 / 28

22
Installation WLC
Release 04 07/2019
Note: At startup, the BAT-Controller WLC needs a time information (date
and time) for the widely automatic configuration of the access points. The
device uses the time for the validation of the required certificates. To set
the time in the device click 'Set Date and Time' in the 'Extras' section in
WEBconfig.
As soon as theWLAN-Controller gets valid time information, it starts the
construction of the certificates. Once the device generated the necessary
certificates, the BAT-Controller WLC indicates that it is operational and
the WLAN LED blinks red.
2.1.3 Configuration via the serial interface
If there is no possibility to establish LAN access to the device, you connect
the computers via the serial configuration interface. Now, configure the
device with LANconfig or a terminal program.
Note: Enter the parameters separate via a command line interface when you
use a terminal program. The most convenient option here is to use
LANconfig.
2.2 The Setup Wizards
Note: When starting the installation for any device, run the Setup Wizard for
the Basic Settings and then run the Check security settings Setup Wizard.
Note: If you alter the WLAN encryption settings (for example, WPA) in the
device when carrying out the configuration via the WLAN interface with the
aid of the Setup Wizards, also alter the WLAN encryption settings for the
WLAN card of the configuration computer.
2.2.1 Setup wizards under LANconfig
When using LANconfig, continue with the configuration by starting the Setup
Wizards (e.g. for basic settings or WLAN). Choose your device from the
selection window and select the button Setup Wizard or use the menu bar to
access Tools E Setup Wizard