Belden 1RU32LCD-BK-K, Руководство пользователя, Страница: 232 / 269

210
Operation
Change a Route - BPX
Change a Route - BPX
1 Select a BPX crosspoint button.
The button is highlighted, indicating that a crosspoint has been pre-selected.
(If a destination is protected, then all the corresponding crosspoint buttons indicate
this - default color is red. Unprotect the destination before pre-selecting a new
crosspoint. See
Protect a Destination - XY , on page 206.)
2 If routes to further destinations are required, then select further crosspoints.

(To made many routes at ounce, like a ‘Gang Take’ in XY panel mode.)
3 If the Take button is enabled on the panel,

press the Take button to make the changed route(s).
(Otherwise, routes are made as crosspoints are pre-selected.)
The routing has been made.
Gang Take - BPX
There is no ‘Gang Take’ mode as such for the BPX panel.

To make routes to more than one destination, simply make a route as described above but
select as many crosspoints as required
before pressing Take . Pressing Take will then make
all selected crosspoint routes.
Note: If the Take button has not been enabled, then crosspoint routes are
automatically made upon selection.