BelAir100SN User Guide
BelAir100SN Access Methods
May 31, 2010
Confidential
Document Number BDTM11001-A01 Released
BelAir100SN Access Methods
When a BelAir100SN is shipped from the factory, all access methods (CLI,
SNMP, Telnet, HTTP, HTTPS and SSH) are enabled. You can use these interfaces
to configure the system’s IP networking parameters.
This chapter describes the CLI commands you can use to configure these
access methods.
Note: Some access methods, such as HTTP and HTTPS, are configured while
in SSL mode.
SNMP
Configuration
Guidelines
This section describes how to configure the BelAir100SN to communicate to
either an SNMPv1/v2 server or an SNMPv3 server.
SNMPv1/v2 Servers
To configure an SNMP community, use the
set community
command described
in
For sending traps, use the
set trap
command described in
to configure the node with the parameters of the destination SNMP manager.
Refer to
“SNMP Command Reference” on page 28
for detailed descriptions of
all SNMP commands.
SNMPv3 Servers
To configure an SNMP user, use the
set user
command described in
For sending notifications, use the
set notify
command described in
to configure the node with the parameters of the
destination SNMP manager.
Refer to
“SNMP Command Reference” on page 28
for detailed descriptions of
all SNMP commands, including entities that need to be predefined.
SNMP Naming
Restrictions
SNMP community names, user names, and notification names must not contain
the following characters:
—bar (|)
—semicolon (;)
—percent (%)
—double quotation mark (“)
