OPTICAL
DIGITAL AUDIO OUTPUTS
ANALOG AUDIO OUTPUTS
CAUTION
RISK OF ELECTRICAL SHOCK.
DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER.
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CERTIFICATION
THIS PRODUCT COMPLIES WITH DHHS RULES 21 CFR.
SUBCHAPTER J. PART 1040 AT DATE OF MANUFACTURE.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE
A
UNDESIRED OPER TIONS.
CLASS I LASER
SERIAL NUMBER
Made in U.S.A
Bel Canto Design, Ltd
Minneapolis, MN USA
RIGHT
RIGHT
LEFT
LEFT
ON
OFF
MAIN POWER
G R O U N D E D A C O U T L E T O N LY
100V 120V 220V
240V
90V-240V AC 50-60Hz ONLY
75W MAXIMUM
SPDIF
AES/EBU
BALANCED
CD-1
REAR PANEL CONNECTIONS
1
2
3
4
5
6
7
8
9 10
11
DIGITAL AUDIO OUTPUTS
1) OPTICAL OUT (TOSLINK):
This output is for use
with a
Toslink
type optical cable. For best results
the cable should be as short as possible. Care
should be taken that there are no sharp bends or
kinks in the cable that would degrade the signal.
2)
RCA
type connector for use with co-axial digital
cable. The highest quality digital cable should be
used on this output.
3)
BNC
type connector for use with co-axial digital
cable. The highest quality digital cable should be
used on this output.
4)
AES/EBU
is a balanced digital output from a male
3-pin XLR connector. This type of balanced signal
offers superior performance due to its higher signal
level and low noise characteristics. The highest
quality digital cable should be used with this
output.
ANALOG AUDIO OUTPUTS
5 & 8)
RCA
type connectors for right and left analog
audio output. This connectors should be
used with high quality analog audio cables
for best performance.
6 & 7)
Male 3-pin XLR
connectors for balanced right
and left analog audio output. This type of
connector offers superior isolation of the signal
and low noise characteristics. For optimum
performance only the best balanced analog
cables should be used.
POWER CONNECTIONS
9) A/C IEC POWER CONNECTOR:
This receptacle
incorporates internal RFI filter circuits to prevent
radio and television interference. It should be
connected to a 3-wire grounded A/C cord and
plugged into a 3-wire, un-switched power outlet.
DO NOT DEFEAT THE GROUND PIN.
10) POWER SETTINGS:
These boxes indicate the
voltage which the unit is set to run on. 100V,
120V, 220V or 240V A/C Single Phase. Unit should
be used only on the voltage specified by the marked
box.
11)
Main Power Switch:
This switch controls the
main power to the unit and should be left in the
on position once the unit is installed. The front
STBY
button will turn off the display and other
circuits leaving only heat sensitive circuits
on.
This assures maximum audio quality without a
lengthy warm-up period. The switch should only
be turned off if the unit is not to be used for long
periods of time.
OPERATING INSTRUCTIONS