Beko WTG921B2, Руководство пользователя

Страница: 35 / 44

35 / EN
Washing Machine / User’s Manual
4.7.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the product and also
at the end of each water intake hose where they are connected to the tap. These filters
prevent foreign substances and dirt in the water to enter the product. Filters should be
cleaned as they do get dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake
valves. Clean them with an appropriate brush. If the filters are too dirty, remove them
from their places with a pliers and clean in this way.
3. Take out the filters on the flat ends of the water intake hoses together with the
gaskets and clean thoroughly under running water.
4. Replace the seals and filters carefully and tighten their nuts by hand.
4.7.5 Draining remaining water and cleaning the pump filter
The filter system in your product prevents solid items such as buttons, coins and fabric
fibers clogging the pump impeller during discharge of washing water. Thus, the water will
be discharged without any problem and the service life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter must be
cleaned whenever it is clogged or in every 3 months. Water must be drained off first to
clean the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water
should be drained completely.
A
CAUTION:
Foreign substances left in the pump filter may damage your product or may
cause noise problem.
CAUTION:
In regions where freezing is possible, the faucet must be closed, system hose
must be removed and the water inside the product must be drained when the product is not
in use.
CAUTION:
After each use, turn off the water tap to which the mains hose is connected.
In order to clean the dirty filter and discharge the water:
1 Unplug the product to cut off the supply power.
A
CAUTION:
Temperature of the water inside the product may rise up to 90 ºC. To avoid the
burning risk, clean the filter after the water inside the product is cooled down.