Washing Machine / User‘s Manual
33 / EN
8
Troubleshooting
Program does not start after closing the door.
• Start / Pause / Cancel button was not pressed. >>>
Press the Start / Pause / Cancel button.
Programme cannot be started or selected.
• Washing machine has switched to self protection mode due to a supply problem (line voltage, water pressure, etc.).
>>>
To cancel the programme, turn the Programme Selection knob to select another programme. Previous programme
will be canceled. (See “Cancelling the programme”)
Water in the machine.
• Some water might have remained in the product due to the quality control processes in the production. >>>
This is
not a failure; water is not harmful to the machine.
There is water leaking from the bottom of the washing machine.
• Likely problems with hoses or the pump filter. >>>
Be sure the seals of the water inlet hoses are securely fitted. Attach
the hose to the tap tightly.
• Pump filter might not be closed fully. >>>
Make sure that the pump filter is completely closed.
Machine does not fill with water.
• Tap is turned off. >>>
Open the inlet water taps fully.
• Water inlet hose is bent. >>>
Flatten the water inlet hose.
• Water inlet filter is clogged. >>>
Clean the water inlet filter.
• The loading door is ajar. >>>
Close the Loading Door.
Machine does not drain water.
• Water drain hose might be clogged or twisted. >>>
Clean or flatten the hose.
• Pump filter is clogged. >>>
Clean the pump filter.
Machine vibrates or makes noise.
• Machine might be standing unbalanced. >>>
Adjust the feet to level the machine.
• A hard substance might have entered into the pump filter. >>>
Clean the pump filter.
• Transportation safety bolts are not removed. >>>
Remove the transportation safety bolts.
• Laundry quantity in the machine might be too little. >>>
Add more laundry to the machine.
• Machine might be overloaded with laundry. >>>
Take out some of the laundry from the machine or distribute the load
by hand to balance it homogenously in the machine.
• Machine might be leaning on a rigid item. >>>
Make sure that the machine is not leaning on anything.
Machine stopped shortly after the programme started.
• Machine might have stopped temporarily due to low voltage. >>>
It will resume running when the voltage restores to
the normal level.
Machine directly discharges the water it takes in.
• Draining hose might not be at adequate height. >>>
Connect the water draining hose as described in the operation
manual.
No water can be seen in the machine during washing.
• The water level is not visible from outside of the washing machine. This is not a failure.
Loading door cannot be opened.
• Door lock is activated because of the water level in the machine. >>>
Drain the water by running the Pump or Spin
programme.
• Machine is heating up the water or it is at the spinning cycle. >>>
Wait until the programme completes.
• Child lock is engaged. Door lock will be deactivated a couple of minutes after the programme has come to an end.
>>>
Wait for a couple of minutes for deactivation of the door lock.