Beko WMB 651241 L, Руководство пользователя

Страница: 8 / 36

8
EN
3 Installation
It is the customers responsibility to arrange
a suitably qualified installer to correctly
install this product. To make the product
ready for use, review the information in
the user manual and make sure that the
electricity, tap water supply and water
drainage systems are appropriate before
calling the qualified Installer. If they are not,
call a qualified technician and plumber to
have any necessary arrangements carried
out.
C Preparation of the location and
electrical, tap water and waste water
installations at the place of installation
is under customer's responsibility.
B Installation and electrical connections
of the product must be carried out by
a qualified installer. Manufacturer shall
not be held liable for damages that may
arise from procedures carried out by
unauthorized persons.
A
Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products cause risks for your safety.
C Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or
crushed while pushing the product into
its place after installation or cleaning
procedures.
Appropriate installation location
• Place the machine on a rigid floor. Do
not place it on a long pile rug or similar
surfaces.
• Total weight of the washing machine
and the dryer -with full load- when
they are placed on top of each other
reaches to approx. 180 kilograms.
Place the product on a solid and flat
floor that has sufficient load carrying
capacity!
• Do not place the product on the power
cable.
• Do not install the product at places
where temperature may fall below 0ºC.
• Place the product at least 1 cm away
from the edges of other furniture.
Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the
ribbon.
Removing the
transportation locks
A
Do not remove the transportation
locks before taking out the packaging
reinforcement.
A Remove the transportation safety
bolts before operating the washing
machine, otherwise, the product will be
damaged.
1. Loosen all the bolts with a spanner until
they rotate freely (C).
2. Remove transportation safety bolts by
turning them gently.