9 - EN
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions from
the left for 3 sec. 1st auxiliary function light will
flash continuously. To deactivate the child-proof
lock, press the same buttons for 3 sec.
Ending the program through canceling
In order to cancel the selected program, press
the “Start/Pause/Cancel” button for 3 seconds.
The machine starts to discharge the water.
“Wash” and “Program Finished” lights will light
up. “Start/Pause/Cancel” and “Wash” lights will
go off after discharging process is over and the
“Lid” light will start flashing. “Lid” lamp will light
up continuously when the door is unlocked.
If the program is cancelled in the middle of
the process, “Wash” and “Program Finished”
lights will light up. The machine can drain all the
water or can take in water for 3 times at most
to cool down the clothes and complete draining
process. When the water discharging process
is completed, the “Wash” light will go off, the
“Program Finished” light will light up and the
“Lid” light will continuously flash until the door is
unlocked.
End of program
The “Program Finished” lamp on the program
follow-up indicator will light up when the program
comes to an end. The lid is unlocked 2 minutes
later, the “Program Finished” and “Lid” lamps will
light up continuously. The machine is now ready
for a second cycle.
If any key is pressed when the machine is at
the end of the program or if the position of
the selection knob is changed, the “Program
Finished” light will go off and only the “Lid” lamp
will remain as lit. If the door is still locked, the
“Lid” light will continue flashing until the door is
unlocked.
Press the “On/Off” button to shut down the
machine.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where they
are connected to the tap. These filters prevent
the foreign substances and dirt in the water to
enter into the machine. Filters should be cleaned
as they get dirty.
•
Close the taps.
•
Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
•
If the filters are very dirty, you can pull them
out by means of pliers and clean them.
•
Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
•
Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
