Beko WEY104064TW, Руководство пользователя

Страница: 9 / 44

9 / EN
Washing Machine / User’s Manual
A
WARNING:
Remove the transportation safety bolts before operating the product! Otherwise, the product will get
damaged.
C
Keep the transportation safety bolts in a safe place to reuse when the product needs to be moved again in the future.
Install the transportation safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
4.1.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have 10 –
80 liters of water flowing from the fully open tap in 1 minute to have your product run smoothly. Attach a pressure reducing
valve if water pressure is higher.
If you are going to use the double water-inlet product as a single (cold) water-inlet unit, you must install the supplied stopper
to the hot water valve before operating the product. (Applies for the products supplied together with a blind stopper group.)
A
WARNING:
Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will
get damaged or the product will switch to protection mode and will not operate.
WARNING:
Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
1 Tighten all hose nuts by hand. Never use a tool when tightening the nuts.
2 Open the taps completely after making the hose connection to check for water leaks at the connection
points. If any leak occurs, turn off the tap and remove the nut. Retighten the nut carefully after checking
the gasket. In order to prevent the water leaks and resultant damages, keep the taps closed when you do
not use the product.
4.1.5 Connecting the drain hose to the drain
• Attach the end of the drain hose directly to waste water drain, washbasin or bathtub.
A
WARNING:
Your house will be flooded if the drain hose is dislocated during water draining. Moreover, there is risk of
scalding due to high washing temperatures! In order to prevent such situations and make sure that the product performs
water intake and drain processes without any problem, fix the drain hose securely.
• Connect the drain hose to a minimum height of 40 cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on the floor level or close to the ground (less than 40 cm
above the ground), water draining becomes more difficult and the laundry may come out excessively wet.
Therefore, observe the heights described in the figure.
40 cm
100 cm