Beko WDIY854310, Руководство пользователя

Страница: 62 / 84

62 / EN
Washer-Dryer
Maintenance and cleaning
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake
valves. Clean residues on them with an appropriate brush. If the filters are too dirty,
remove them from their places with a pliers and clean in this way.
3. Take out the filters on the flat ends of the water intake hoses together with the
gaskets and clean thoroughly under running water.
4. Replace the gaskets and filters carefully in their places and tighten the hose nuts
by hand.
6.5 Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and
fabric fibers clogging the pump impeller during discharge of washing water. Thus,
the water will be discharged without any problem and the service life of the pump
will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned
whenever it is clogged or in every 3 months. Water must be drained off first to clean
the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house)
and in case of freezing of the water, water may have to be drained completely.
A
CAUTION
• Foreign substances left in the pump filter may damage
your product or may cause noise problem.
• If the product is not being used, shut the tap, remove
mains hose and drain the water inside the machine in
places where there is the risk of the product freezing .
• After each use, turn off the water tap to which the
mains hose is connected.
In order to clean the dirty filter and discharge the water:
1. Unplug the machine to cut off the supply power.
A
CAUTION
• Temperature of the water inside the machine may
rise up to 90 ºC. To avoid burning risk, filter must be
cleaned after the water in the machine cools down.
2. Some of our products have emergency draining hose and some does not have.
Follow the steps below to discharge the water.