Beko VOLTAS WFL6010VPWW, Руководство пользователя

Страница: 8 / 32

8 / EN
Washing Machine / User Manual
4.1.4 Connecting water supply
C
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
10 – 80 liters of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a
pressure reducing valve if water pressure is higher.
A
CAUTION:
Models with a single water inlet should not be connected to the hot water tap. In such a case the
laundry will get damaged or the product will switch to protection mode and will not operate.
CAUTION:
Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry
and water leakage damages.
Nuts
Screwdriver
Screw
Bushing
Fig c
Fig b Fig e Fig d
inlet hose
connector
water inlet
take out
hose
Cap
Fig a
1 Press down the cap, remove the inlet hose
connector as shown in Fig a.
2 Loosen four screws on the inlet hose connector,
put the connector on the tap as shown in Fig b. If
the tap caliber is too large and the connector can
not put on it, loosen four screws and remove the
bushing as shown in Fig c.
3 Tighten four screws as shown in Fig d.
4 Tighten nuts as shown in Fig e.
Fig f
5 Tighten the nut by hand to connect the hose to
washing machine as show in Fig f. Never use a
tool when tightening the nut.
6 When hose connection is completed, check
whether there are leakage problems at the
connection points by opening the taps fully. If
any leaks occur, turn off the tap and remove the
nut. Retighten the nut carefully after checking
the seal. In order to prevent the water leaks and
resultant damages, keep the taps closed when
you do not use the product.
4.1.5 Connecting the drain hose to the drain
• Attach the end of the drain hose directly to waste water drain, lavatory or bathtub.
A
CAUTION:
Your drain house will be flooded if the hose comes out of its housing during water discharge.
Moreover, there is risk of scalding due to high washing temperatures! In order to prevent such situations and
make sure that the machine performs water intake and discharge processes without any problem, fix the drain
hose securely.
40 cm
100 cm
• Connect the drain hose to a minimum height of 40
cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on
the floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
• To prevent the waste water to go back into the machine again and to ensure easy drainage, do not
immerse the end of the hose into the waste water or do not insert it into the drain for more than
15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be
pinched between the drain and the machine.