EN
9
4.
The appliance should be
located on a smooth surface. The two
front feet can be adjusted as required.
To ensure that, your appliance is
standing upright adjust the two
front feet by turning clockwise or
anti-clockwise, until the product is in
firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
5.
Refer to “Cleaning and Care”
section to prepare your appliance for
use.
6.
This appliance has been
designed to operate in ambient
temperatures b10 and +32
degrees C (50 and 90 degrees F).
There fore if the appliance is installed
in an unheated / cold room (E.g.:
Conservatory /annex / shed / garage
etc.) then the appliance may not
operate and as a result the storage
time of food may be reduced.
7.
A special receptacle is supplied
to store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.
8.
The space in the room where
the appliance is installed must not be
smaller than 10 cubic metres.
9.
Your product requires adequate
air circulation to function efficiently.
If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the side
walls.If the product will be placed
in an alcove, remember to leave at
least 5 cm clearance between the
product and the ceiling, rear wall and
the side walls. Check if the rear wall
clearance protection component is
present at its location (if provided
with the product). If the component
is not available, or if it is lost or fallen,
position the product so that at least
5 cm clearance shall be left between
the rear surface of the product and
the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
WARNING
Do not locate extension sockets
or
charging
transformers/power
supplies
or
Lithium-Ironbattery
operated products adjacent to the
compressor as they could overheat.
