EN
8
From Cookers
2” (50 mm)
From Radiators
12” (300 mm)
From Refrigerators or Freezers 1” (25 mm)
Allow a minimum of 60 mm (2.4
inches) between the top of the fridge
and the ceiling or the underside of a
wall cupboard.
3
.
Make sure that sufficient room is
provided around the appliance to
ensure free air circulation.
4. Fit the two plastic wall spacers
supplied with the appliance rotating
1/4 turn to the condenser at the back
of the refrigerator (see diagram).
5. The appliance should be located on
a smooth surface. The two front feet
can be adjusted as required. To ensure
that your appliance is standing upright
adjust the two front feet by turning
clockwise or anti-clockwise, until the
product is in firm contact with the
floor. Correct adjustment of feet avoids
excessive vibration and noise.
6. Refer to cleaning and care section
to prepare your appliance for use.
7. This appliance has been designed
to operate in ambient temperatures
be10 and +32 degrees C
(50 and 90 degrees F).Therefore if the
appliance is installed in an unheated /
cold room (E.g.: Conservatory /annex /
shed / garage etc.) then the appliance
may not operate and as a result the
storage time of food may be reduced.
8.
A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance.
In the case of transportation, ensure
you locate the plug in the receptacle
provided to avoid transit damage.
The following guidelines and
recommendations are suggested to
obtain the best results and storage
hygiene.
1. The larder fridge is suitable for the
short term storage of fresh food and
drinks.
2. Cooked dishes must be stored in
airtight covered containers.
