DO'S AND DON'TS
Do- Clean your larder refrigerator regularly.
Do- Keep raw meat and poultry below cooked food and dairy products and ideally in
the chiller zone compartment drawer.
Do- Keep food for as short a time as possible and adhere to 'Best Before' and
"Use By" dates.
Do- Take off any unusable leaves on vegetables and wipe off any soil.
Do- Leave lettuce, cabbage, parsley and cauliflower on the stem.
Do- Wrap cheese firstly in greaseproof paper and then in a polythene bag
excluding as much air as possible.
Do- Wrap meat, fish and offal in polythene bags.
Do- Wrap food which have a strong odour or can dry out in polythene bags
aluminium foil or place in airtight container.
Do- Wrap bread well to keep it fresh.
Do- Chill white wines, beer, lager and mineral water before serving.
Don't- Store bananas in your fridge.
Don't- Store melon in your fridge. It can be chilled for short periods as long as it
is wrapped to avoid it flavouring other food.
Don't- Leave the door open for long periods as this will make the larder
refrigerator more costly to run.
Don't- Store poisonous or any dangerous substances in the larder refrigerator.
Your larder refrigerator has been designed for the storage of edible
foodstuffs only.
Don't- Consume food which has been stored for an excessive time in the
larder refrigerator.
Don't- Store cooked and fresh food together in the same container. They should
be packaged and stored separately.
Don't- Let defrosting food or food juices drip onto food in your larder
refrigerator.
PROBLEM SOLVING
If the appliance does not operate when switched on, check;
• The plug is inserted properly in the socket and that the power supply is on. (To
check the power supply to the socket, plug in another appliance)
• The fuse has blown/circuit breaker has tripped/main distribution switch has
been turned off.
• The temperature control has been set correctly.
• New plug is wired correctly if you have changed the fitted moulded plug.
If the appliance is still not operating after the above checks, please refer to the section on
“How To Obtain Service”.
Please ensure that above checks have been made as a charge will be made if no
fault is found.
REPLACING THE INTERIOR LIGHT BULB (See diagram)
Should the light fail to work switch off at the socket outlet and pull out the mains
plug.
Use a cross headed screw driver to remove the light diffuser cover.
Then ensure the bulb is screwed in until it is secure in the bulb holder. Replace the
plug and switch on.
If the bulb functions, reassemble by reversing the above procedure, ensure the top
cover is in place.
If the light still fails to work obtain a replacement screw cap type 15 Watt (Max)
bulb from your local electrical store and then fit it as follows.
1. Switch off at the socket outlet and pull out the mains plug.
You may find it useful to remove shelves for easy access.
2. Remove the light diffuser cover screw. Use cross-headed screw driver.
3. Pull off the light diffuser cover and remove the light bulb.
4. Replace the burnt-out light bulb.
5. Reassemble reversing the sequence and operations. First ensure the top of the
cover is in place.
6. Carefully dispose of the burnt-out light bulb immediately.
"Replacement light bulb can easily be obtained from a good local electrical or DIY
store."
13
14
