TRANSPORTATION INSTRUCTIONS
1. The refrigerator should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.
2.
3. Failure to comply with the above instructions could result in damage occuring
to the refrigerator. The manufacturer will not be held responsible if these
instructions are disregarded.
4. The refrigerator must be protected against rain, moisture and other
atmospheric influences.
IMPORTANT : Care must be taken while cleaning / carrying the appliance to
avoid touching the bottom of the condenser metal wires at the back of the
appliance as you might injure your fingers and hands.
Important : This appliance is not designed for stacking with any other
appliance.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.
"IMPORTANT: Make sure that mains cable is not caught under the appliance
during and after carrying / moving the appliance, to avoid the mains cable
becoming cut or damaged."
When positioning your appliance take care not to damage your flooring, pipes,
wall coverings etc. Do not move the appliance by pulling by the door or handle.
Do not allow children to play with the appliance or tamper with the controls.
BEKO plc declines to accept any liability should the instructions not be followed.
IMPORTANT
INSTALLATION INSTRUCTIONS
4
5
If during the course of transport the appliance has to be transported horizontally,
it must only be laid on its left hand side when standing in the front of the
appliance. After bringing it to upright position,it must not be operated for at least
4 hours to allow the system to settle.
5. Empty any water in the drain tray before moving see section “Defrosting” and
“Cleaning & Care” for further information.
IMPORTANT : Make sure the plastic evaporating pan at the back of the product
collects water properly.
1. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as
this will cause the compressor to run for long periods. If installed next to a source of heat
or refrigerator, maintain the following minimum side clearances:
2. No gap is required at sides and top. See item 3 below to ensure a gap is obtained at
the rear of the appliance. If a gap is available on side and top, retain it if possible as it
would improve the air circulation around the appliance.
3. Fit the two plastic wall spacers supplied with the
appliance rotating 1/4 turn to the condenser at the
back of the appliance (see diagram).
4. The fridge should be located on a smooth surface.
The two front feet can be adjusted as required. To
ensure that, your fridge is standing upright adjust the
two front feet by turning clockwise or anti-clockwise,
until the product is in firm contact with the floor. Correct
adjustment of feet avoids excessive vibration and noise.
5. Refer to "Cleaning and Care" section to prepare
your appliance for use.
6. This appliance has been designed to operate in ambient temperatures b10
and +32 degrees C (50 and 90 degrees F). There fore if the appliance is installed in an
unheated / cold room (E.g.: Conservatory /annex / shed / garage etc.) then the appliance
may not operate and as a result the storage time of food may be reduced.
7. A special receptacle is supplied to store the mains
plug during transit. The receptacle is fixed at the back
of the cabinet, on the right hand side of the compressor.
(See diagram) Gently remove the plug from the
receptacle. Never pull the mains cord, you may damage
the appliance. In the case of transportation, ensure
you locate the plug in the receptacle provided to avoid
transit damage.
8. The space in the room where the appliance is installed must not be smaller than 10
cubic metres.
From Cookers
2" (50 mm)
From Radiators
12" (300 mm)
From Refrigerators or Larder fridges
1" (25 mm)
