EN
9
improve the air circulation around the
appliance.
3.
Fit the two plastic wall spacers
supplied with the appliance on to
the condenser at the back of the
refrigerator by rotating 1/4 turn (see
diagram).
4.
The appliance should be
located on a smooth surface. The two
front feet can be adjusted as required.
To ensure that your appliance is
standing upright adjust the two
front feet, by turning clockwise or
anti-clockwise, until the product is in
firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
5.
Refer to “Cleaning and Care”
section to prepare your appliance for
use.
6.
This appliance has been
designed to operate in ambient
temperatures b10 and +32
degrees C (50 and 90 degrees F).
Therefore if the appliance is installed
in an unheated / cold room (E.g.:
Conservatory /annex / shed / garage
etc.) then the appliance may not
operate and as a result the storage
time of food may be reduced.
7.
A special receptacle is supplied
to store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.
8.
The space in the room where
the appliance is installed must not be
smaller than 10 cubic metres.
