Beko HTZG 64120, Руководство пользователя

Страница: 11 / 17

11/EN
DANGER:
The product must be connected to the
mains supply only by an authorised and
qualified person. The product's
warranty period starts only after correct
installation.
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
DANGER:
The power cable must not be clamped,
bent or trapped or come into contact
with hot parts of the product.
A damaged power cable must be replaced
by an Authorised Service Agent. Otherwise,
there is risk of electric shock, short circuit
or fire!
The mains supply data must correspond to the
data specified on the type label of the product.
Type label is at the rear housing of the product.
Power cable of your product must comply with
the values in "Technical specifications" table.
Power cable plug must be within easy reach
after installation (do not route it above the
hob).
DANGER:
Before starting any work on the
electrical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Plug the power cable into the socket.
Gas connection
DANGER:
Product can be connected to gas
supply system only by an authorised
and qualified person.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
DANGER:
Before starting any work on the gas
installation, disconnect the gas supply.
There is the risk of explosion!
• Gas adjustment conditions and values are
stated on labels (or ion type label).
Your product is equipped for liquefied
petroleum gas (LPG).
Connecting the gas hose
• Have your product connected in a way that
it will be close to the gas connection and
not gas leakage will exist.
• Plastic hose to be used must not be longer
than 125 cm.
• Install the clamp to the hose. Soak one end
of the hose (15 mm inner diameter) into
boiling water for one minute to soften it.
• Than, slip the softened end of the hose
completely onto the sharp hose tip of your
product. Finally, tighten the clamp
completely with a screwdriver.
• Repeat the same procedure for the other
end of the hose and complete the gas
cylinder connection.
• Never forget to make the gas leakage
control.
DANGER:
Risk of explosion and suffocation!
Do not keep LPG cylinders in home.
• If you need to use your product later with a
different type of gas, you must consult the
Authorised Service Agent for the related
conversion procedure.