Beko GNEV021APW, Руководство по установке и эксплуатации

Страница: 6 / 28

EN
6
ELECTRICAL
REQUIREMENTS
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown on the rating plate
inside the appliance corresponds to your
electricity supply.
Rating label is on the left hand side of
fridge inner liner.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket. The
appliance must be positioned so that the
plug is accessible.
Should the mains lead of the appliance
become damaged or should it need
replacing at any time, it must be
replaced by a special purpose made
mains lead which can only be obtained
from a BEKO Authorised Service Agent.
WARNING! THIS APPLIANCE
MUST BE EARTHED
If the fitted moulded plug is not suitable
for your socket, then the plug should be
cut off and an appropriate plug fitted.
Destroy the old plug which is cut off as
a plug with bared cord could cause a
shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance
incorporates a 13 A fuse. Should the
fuse need to be replaced an ASTABEAB
approved BS 1362 fuse of the same
rating must be used. Do not forget to
refit the fuse cover. In the event of losing
the fuse cover the plug must not be
used until a replacement fuse cover has
been fitted. Colour of the replacement
fuse cover must be the same colour as
that visible on the pin face of the plug.
Fuse covers are available from any good
electrical store.
IMPORTANT! FITTING A DIFFERENT
PLUG
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug
proceed as follows: (See diagram).
1. Connect the green-yellow or green
(Earth) wire to the terminal in the plug
marked ‘E’ or with the symbol or
coloured green and yellow or green.
2. Connect the blue (Neutral) wire to
the terminal in the plug marked ‘N’ or
coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked ‘L’ or
coloured red.
With alternative plugs a 13 A fuse must
be fitted either in the plug or adaptor or
in the main fuse box. If in doubt contact
a qualified electrician.
FITTED WITH
BS 1362 13A FUSE ALWAYS FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22mm.
6mm.
6mm.
6mm.
32mm.
12mm.
FUSE
CORD GRIP