Beko FREEZ55FW, Инструкция по установке, эксплуатации и хранению продуктов

Страница: 8 / 21

EN
7
3 Installation
INSTALLATION
INSTRUCTIONS
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2. If possible avoid placing the
appliance near cookers, radiators or
in direct sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat
or refrigerator, maintain the following
minimum side clearances:
2” (50 mm) From Cookers
12” (300 mm) From Radiators
From Refrigerators or Freezers
1” (25 mm)
3. Make sure that sufficient room
is provided around the appliance
to ensure free air circulation. Allow
a minimum of 60 mm (2.4 inches)
between the top of the appliance and
the ceiling or the underside of a wall
cupboard.
4. Fit the two plastic wall spacers
supplied onto the condenser at the
back of the appliance by rotating them
1/4 turn.
5. The appliance should be located on
a smooth surface.
The two front feet can be adjusted as
required.
To ensure that,your appliance is
standing upright adjust the two front
feet by turning clockwise or anti-
clockwise, until the product is in
firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
6. Refer to “Cleaning and Care”
section to prepare your appliance for
use.
7 .A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage. transit
provided to avoid transit damage.
8.
The appliance must be protected
against rain, moisture and other
atmospheric influences.