Beko ECO WMB 81445 LW, Инструкции по установке и эксплуатации, а также рекомендации по стирке

Страница: 37 / 44

37 / 44 EN
Troubleshooting
Foam is overflowing from the detergent drawer.
• Too much detergent is used. >>> Mix 1 tablespoonful softener and ½ l water and pour into the main wash
compartment of the detergent drawer.
• Put detergent into the machine suitable for the programmes and maximum loads indicated in the “Programme
and consumption table”. When you use additional chemicals (stain removers, bleachs and etc), reduce the
amount of detergent.
Laundry remains wet at the end of the programme
• Excessive foam might have occurred and automatic foam absorption system might have been activated due to
too much detergent usage. >>> Use recommended amount of detergent.
• Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any
damage to the machine and to its surrounding environment. Laundry should be rearranged and re-spun.
A
WARNING:
If you cannot eliminate the problem although you follow the instructions in this section,
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional product
yourself.
Machine does not start. Nothing appears on the display.
Machine may be unplugged. >>>
Check the plug and attach it to the socket.
Fuse may be defective. >>>
Check the fuse and have it replaced by a qualified electrician if necessary.
Power may be out. >>>
Check if there is any power outage.
On / Off button might not be pressed. >>>
Press On / Off button.
Machine does not start when Start / Pause / Cancel button is pressed after selecting the programme.
Loading door may be open. >>>
Close the loading door.
Rinse symbol flashes in the display. (No Water symbol may also be lit depending on the model of your
machine).
Water may be cut off. >>>
Make sure that the water is not cut off and press Start / Pause / Cancel button
again to start your machine.