Beko DRYPOINT RA HT 100-P NA UL, Инструкция по установке и эксплуатации

Страница: 27 / 52

Maintenance, troubleshooting, spare parts and dismantling
DRYPOINT® RA HT 20-350 NA UL 27
DAILY:
• Check whether the dew point indicated on the electronics is correct.
• Ensure that the condensate drain system functions properly.
• Make sure that the condenser is clean.
EVERY 200 HOURS OR MONTHLY
• Clean the condenser using an air jet (max. 2 bar / 30 psig) inside out. Make
sure not to damage the aluminium lamellae of the cooling package.
• Finally, verify the operation of the device.
EVERY 1000 HOURS OR YEARLY
•
Verify for tightness all the screws of the electric system and that all the “Faston” type connections are
in their proper position, inspect unit for broken, cracked or bare wires.
•
Inspect refrigerating circuit for signs of oil and refrigerant leakage.
•
Measure and record amperage. Verify that readings are within acceptable parameters as listed in
specification table.
•
Inspect condensate drain flexible hoses, and replace if necessary.
•
Replace the filter element (cartridge) of the Pre-
Filter (1 micron). Refer to the instructions in the user’s
and maintenance manual of the filter for this operation.
•
At the end, check the operation of the machine.
EVERY 8,000 HOURS
• Replace BEKOMAT Service Unit.