14
Dishwasher / User’s Manual
/39 EN
Preparation
Test Strip
Let the water
flow from your
tap for 1 minute.
Remove the
test strip from
its packing.
Fill a glass with
tap water and
dip the test strip
into water for 1
second.
Take the test strip
out of the water and
shake it.
Hold for
1 minute.
Set the water hardness level of your dishwasher
according to the result shown by the test strip.
No Lime
Very low lime content
Low lime content
Medium lime content
High lime content
Very High lime content
Level 1
Level 2
Level 3
Level 4
Level 5
Level 6
To Adjust the Water Hardness
1. After turning on the machine, press and hold Time Delay and Programme keys
simultaneously for 3 seconds to enter the settings menu.
2. Press the programme key until the Rinse Aid icon starts to flash. Current regeneration
stage is displayed on the programme indicator.
3. Using Time Delay key, adjust water hardness level according to the hardness of the
supply water. See “Water hardness level adjustment table” for correct setting.
4. Press On / Off key to save the setting.
Water Hardness Level Adjustment Table
Hardness
Level
English
Water
Hardness
°dE
German
Water
Hardness
°dH
French
Water
Hardness
°dF*
Position of
Regeneration
Adjustment
Switch**
Water Hardness Level Indicator
1
st
Level
0-5
0-4
0-8
Press the Time Delay key to switch the
water hardness level to position P1.
2
nd
Level
6-9
5-7
9-13
3
rd
Level
10-15
8-12
14-22
Press the Time Delay key to switch the
water hardness level to position P2.
4
th
Level
16-19
13-15
23-27
Press the Time Delay key to switch the
water hardness level to position P3.
5
th
Level
20-24
16-19
28-34
Press the Time Delay key to switch the
water hardness level to position P4.
6
th
Level
25-62
20-50
35-90
Press the Time Delay key to switch the
water hardness level to position P5.
Perform the same hardness
level adjustment that you
have set on the control panel
also with the regeneration
adjustment switch. For
example, if you have adjusted
to “3” in the control panel,
also set the regeneration
adjustment switch to 3.
** Regeneration Adjustment
Switch
If the hardness level of the water that you use is above 90°dF (French standard for water
hardness) or if you are using well water, than it is recommended to use filter and water
purification devices.
* If the hardness level of the water that you use is below 8°dF (French standard for
water hardness), there is no need to use salt in your dishwasher. If this is the case, Salt
Indicator (if any) illuminates continuously on the panel of your machine.
If the water hardness is set to level 1, the Salt Indicator will illuminate continuously
although it is not necessary to use salt. If you use salt under this condition, salt will not
be consumed and the lamp will not illuminate.
