14 / EN
Dryer / User Manual
3
Installation
Before the calling the nearest Authorized
Service for the installation of the dryer, en-
sure that electrical installation and water
drain is appropriate referring to the user's
manual.
(See 3.3 Connecting to the drain and
3.5 Electrical connection)
If they are not
suitable, contact a qualified electrician and
technician to make necessary arrangements.
C
Preparation of the dryer's location
as well as the electrical and
waste water installations is under
customer's responsibility.
A
Prior to installation, visually check
if the dryer has any defects on it. If
the drier is damaged, do not have
it installed. Damaged products
cause risks for your safety.
3.1 Appropriate installation
location
Install the dryer on a stable and level surface.
Dryer is heavy. Do not move it by yourself.
• Operate your dryer in a well ventilated,
dust-free environment.
• The gap between the dryer and the
surface should not be reduced by the
materials such as carpet, wood and tape.
• Do not cover the ventilation grills of the
dryer.
• There must not be a lockable, sliding or
hinged door that may block the opening
of the loading door in the place where
your dryer is to be installed.
• Once the dryer is installed, it should stay
at the same place where its connections
have been made. When installing the
dryer, make sure that its rear wall does
not touch anywhere (tap, socket, etc.).
• Place the dryer at least 1 cm away from
the edges of other furniture.
• Your dryer can be operated at
temperatures b5°C and +35°C.
If the operating conditions fall outside
of this range, operation of the dryer
will be adversely affected and it can get
damaged.
• The rear surface of the tumble dryer shall
be placed against a wall.
B
Do not place the dryer
on the
power cable.
3.2 Removing the
transportation safety assembly
A
Remove the transportation safety
assembly before using the dryer
for the first time.
Open the loading door.
There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it from its
section marked with
XX XX.
Pull the nylon towards yourself and remove
the transportation safety assembly.
A
Check that no part of the
transportation safety assembly
remains inside the drum.
3.3 Connecting to the drain
In products equipped with condenser unit,
water accumulates in the water tank during
the drying cycle. You should drain accumu-
lated water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining
the water collected in the water tank.
Please refer to the detailed instructions sup-
plied with the accessories pack.
Connecting the water drain hose
1-2
Pull hose at the behind of the dryer by
hand in order to disconnect it from where
it is connected. Do not use any tools to
remove the hose.
3
Connect one end of the drain hose
supplied with the dryer to the connection
point from where you removed the hose
of the product in previous step.
