2
Instructions for use
Electrical requirements
Before inserting the plug into the wall socket
make sure that the voltage and the
frequency shown in the rating plate inside the
appliance corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitably switched and fused socket in a readily
accessible position.
Warning! This appliance must be
grounded.
Repairs to electrical equipment should only be
performed by a qualified technician. Incorrect
repairs carried out by an unqualified person
are carry risks that may have critical
consequences for the user of the appliance.
Transportation
instructions
1.
The appliance should be transported only
in a upright position. The packing as supplied
must be intact during transportation.
2.
If during the course of transport the appliance,
has been positioned horizontally, it must not
be operated for at least 4 hours, to allow the
system tosettle.
3.
Failure to comply with the above instructions
could result in damage to the appliance, for
which the manufacturer will not be held liable.
4.
The appliance must be protected against
rain, moisture and other atmospheric influences.
Important!
•
Do not attempt to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
•
Make sure that the mains cable is not caught
under the appliance during and
after moving, as this could damage the cable.
•
Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1.
Do not keep your appliance in a room where
the temperature is likely to fall below 10 degrees
C at night and/or especially in winter, as it is
designed to operate in ambient temperatures
b10 and +43 degrees C. At lower
temperatures the appliance may not operate,
resulting in a reduction in the storage life of
the food.
2.
Do not place the appliance near cookers
or radiators or in direct sunlight, as this will
cause extra strain on the appliance's functions.
If installed next to a source of heat or a freezer,
maintain the following minimum side clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3.
Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
• Fit the two round wedges given with your
refrigerator to their places. These wedges
provide free air-circulation better and set the
distance between the refrigerator and the wall
while preventing your refrigerator from standing
upright against the wall completely
(Fig. 2
).
• Fit the bottom airing lid given in your appliance
as shown in the diagram to the pins facing one
another on the feet at the bottom of the door.
Make sure claws and pins to hold each other
for the pins-claws connection
(Fig. 3
).
4.
The appliance should be positioned on a
smooth surface. The two front feet can be
adjusted as required.To ensure that your
appliance is standing upright adjust the two
front feet by turning clockwise or counter
clockwise, until firm contact is secured with the
floor. Correct adjustment of feet prevents
excessive vibration and noise.
5.
Refer to "Cleaning and Care" section to
prepare your appliance for use.
Содержание D 9400 NM
Страница 1: ...D 9400 NM Instructions for use ...
Страница 3: ...Fig 1 1 2 3 4 5 5 6 5 13 14 16 16 16 16 15 14 17 7 8 9 11 12 10 ...
Страница 4: ...Fig 2 Fig 3 Fig 4 Fig 5 Fig 7 Fig 6 Fig 8 Fig 9 3 1 2 4 ...
Страница 5: ...Fig 10 Fig 11 Fig 12 ...
