Beko CFMD7852X, Инструкция по установке, эксплуатации и хранению продуктов

Страница: 10 / 31

EN
9
• The voltage stated on the label located at
left inner side of your product should be
equal to your network voltage.
•
Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
Product must not be operated before it is
repaired! There is the risk of electric shock!
Disposing of the packaging
The packing materials may be dangerous
for children. Keep the packing materials out
of the reach of children or dispose of them
by classifying them in accordance with
the waste instructions stated by your local
authorities. Do not throw away with regular
house waste, throw away on packaging
pick up spots designated by the local
authorities.
The packing of your cooler/freezer is
produced from recyclable materials.
Disposing of your old cooler/
freezer
Dispose of your old cooler/freezer without
giving any harm to the environment.
• You may consult your authorized dealer
or waste collection center of your
municipality about the disposal of your
cooler/freezer.
Before disposing of your cooler/freezer,
cut out the electric plug and, if there are any
locks on the door, make them inoperable in
order to protect children against any danger.
Placing and Installation
A
If the entrance door of the room where
the cooler/freezer will be installed is not
wide enough for the cooler/freezer to pass
through, then call the authorized service to
have them remove the doors of your cooler/
freezer and pass it sideways through the
door.
1.
Install your cooler/freezer to a place that
allows ease of use.
2.
Keep your cooler/freezer away from heat
sources, humid places and direct sunlight.
3.
There must be appropriate air ventilation
around your cooler/freezer in order to
achieve an efficient operation. If the cooler/
freezer is to be placed in a recess in the
wall, there must be at least 5 cm distance
with the ceiling and at least 5 cm with the
wall. Do not place your product on the
materials such as rug or carpet.
4.
Place your cooler/freezer on an even floor
surface to prevent jolts.
Adjusting the legs
If your refrigerator is unbalanced;
You can balance your refrigerator by
turning its front legs as illustrated in the
figure. The corner where the leg exists is
lowered when you turn in the direction of
black arrow and raised when you turn in
the opposite direction. Taking help from
someone to slightly lift the refrigerator will
facilitate this process.
Changing the illumination
lamp
To change the Bulb/LED used for
illumination of your refrigerator, call your
Authorized Service.