EN
9
ensures that at the advised setting
[4 - four on the knob] the frozen food
in the freezer will not defrost even
if the ambient temperature falls as
low as -15 °C. When first installed the
product MUST NOT be placed in low
ambient temperatures because the
freezer will not reduce to it’s standard
operating temperature. Once it
has reached its steady operating
state it can be re-located. So you
may then install your appliance in a
garage or an unheated room without
having to worry about frozen food in
the freezer being spoilt. However at
low ambient temperatures mentioned
above, fridge contents are likely to
freeze, so check and consume food
in the fridge accordingly. When the
ambient temperature returns to
normal, you may change the knob
setting to suit your needs. If the
ambient temperature is below 0°C,
the food in the fridge compartment
will freeze. So, we recommend you
don’t use the fridge compartment
in such low ambient conditions.
You can continue using the freezer
compartment as usual.
3.
Do not place the appliance
near cookers, radiators or in direct
sunlight as this will cause your
appliance to work harder. If installed
next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 50 mm (2”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
4.
Make sure that sufficient room
is provided around the appliance to
ensure free air circulation. Fit the
Two plastic wall spacers supplied
with the appliance rotating 1/4 turn
to the condenser at the back of the
appliance (See Diagram).
5.
The fridge/freezer should
be located on a smooth surface.
The two front feet can be adjusted
as required. To ensure that your
appliance is standing upright adjust
the two front feet by turning
clockwise or anti-clockwise, until
the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
6.
Refer to cleaning and care
section to prepare your appliance for
use.A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back
of the cabinet, on the side of the
compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.